Candy TRIO 9503 X - Manual (Page 11)

The water softener can treat water with a hardness level of up to 60 Fh (French grading) or 33 Dh (German grading) through 5 settings.
The settings are listed in the panel below:
Regulating the water softener with electronic programmer
10 GB
Level
Water hardness
fH (French)
Water hardness
dH (German)
Use of regenerating
salt
Water softener
setting
0
1
2
3
4
0-8
9-20
21-30
31-40
41-60
4
5-11
12-17
18-22
23-33
no
yes
yes
yes
yes
Indicator light N.1
Indicator light N.1
Indicator light N. 2
Indicator light N. 3
Indicator light N. 4
The softener unit is set in the factory at level 3 (indicator light N.3) as this is suitable for the majority of users.
Regulate the setting of your water softener unit according to the degree of hardness of your water as follows: Open the door, press
On / Off button, within 2 minutes press and keep pressed for at least 10 seconds the Programme Selection button; the first three LEDs
on the left turn on for 3 seconds.
The LED associated with the set water softener starts flashing; successive button pushing will set the water hardness levels (see table).
Information for the test laboratories General programme comparison
Ref. EN 50242 standards:
1) Normal load
2) Shine setting: "4"
3) Amount of detergent: 18gr. for wash
USE
WASHING PROGRAMME
PROGRAMME SELECTION BUTTON LEDs