Candy TRIO 9503 X - Manual (Page 14)

TROUBLESHOOTING
REMEMBER! the oven and the dishwasher cannot be used in the same time.
Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks:
13 GB
FAULT
1 - Machine completely dead
CAUSE REMEDY
Plug is not connected correctly
O/I button has not been pressed
No electricity
Door is open Connect electric plug
Press button
Check the electricity supply
Close door
2 - Machine does not drawwater
See causes for No 1
Water tap is turned off
Programme selector is not at correct position
The inlet hose is bent
The inlet hose filter is blocked Check
Turn water tap on
Turn programme selector to correct position
Eliminate the bends in the hose
Clean the filter at the end of the hose
3 - Machine does not discharge water
Filter is dirty
Outlet hose is kinked
The outlet hose extension is not correctly connected
The outlet connection on the wall is pointing
downwards not upwards
Clean filter
Straighten outlet hose
Follow the instructions forconnecting the outlet
hose carefully
Call a qualified technician
4 - Machine discharges water continuously
Lift outlet hose to at least 40 cm
above floor level Position of outlet hose is too low
5 - Spray arm is not heard to rotate
Reduce amount of detergent
Check
Clean plate and cup filter
Excessive amount of detergent
Item prevents arm from rotating
Plate and cup filter very dirty
6 - On electronic appliance without a
display: "Eco" indicator light and indicator
light "No 1", with audible signal
Switch off the appliance - Turn on the
tap - Re-set the cycle Water inlet tap turned off
7 - Load of dishes is only
partially washed
Check
Burnt on food remains must be soaked before
putting pans indishwasher
Reposition saucepans
Remove spray arm by unscrewing ring nut
clockwise and wash under running water
Do not place the dishes too closely together
The end of the outlet hose must not come into
contact with the outflow water
Increase the measure according to how dirty
the dishes are and change detergent
Tighten it fully.
Choose a more vigorous programme
See causes for No 5
Bottom of saucepans have not been washed well
Edge of saucepans have not been washed well
Spray arm is blocked
The dishes have not been properly loaded
The end of the outlet hose is in thewater
The incorrect amount of detergent has been
measured out; the detergent is old and hard
The tap of the salt dispenser is not closed very well
The wash programme is not thorough enough
8 - Presence of white spots on dishes
Check salt and rinse aid level and regulate
amount. Should the fault persist, contact Service
Centre Water is too hard
9 - Noise during wash Load dishes better onto the basket
Load dishes better
The dishes knock against one another
The revolving arm knock against the dishes
10 - The dishes are not
completely dry
L e a v e t h e d i s h w a s h e r d o o r a j a r a t
the end of wash program to allow dishes to dry
naturally Inadequate air flow