Candy PC PSL 750 SX - Manual (Page 48)

Adapting to different types of gas
If it is necessary to adapt the cooktop to gas different than that for which it is designed, the injectors will have
to be replaced. The spare injectors, if not provided with the cooktop, are avail able at the Service Centres.
The injectors to be replaced should be selected according to the injectors table. The injectors are identified
by their diameter, expressed in hundredths of mm and printed on the body of the injectors themselves.
Replacement of the injectors
Remove the grates and the flame spreader from the cooktop.
Use an open-end spanner to replace the injectors J (fig. 10) with the appropriate injectors for the gas
to be used.
Reassemble the burners.
No primary air regulation is necessa ry for the burners .
Adjustment of the minimum
After replacing the injectors, light the burner and take off the knob. Move the tap to the minimum position,
insert a screwdriver in the rod and adjust as follows: screw in to decrease the flame, unscrew t o increase the
flame. (fig. 10)
For G30/G31 gas, screw the adjustment screw in completely .
In any case, the result should be a small flame which is uniform and regular along the entire crown of the
burner. Finally, check that the flame does not go out when the tap is turned quickly from maximum to
minimum position. For burners with safety valves, check that the flame slightly licks the thermocouple. Verify
the correct adjustment by leaving the burner on for a few minutes. If it goes out, increase the mi nimum.
Using the grates
The cooktop grates have been designed to make the use of the product convenient and safe. We
recommend that you check, before each use, the exact positioning and stability of the grate on the cooktop.
Furthermore, check that th e rubber supports are always intact and arranged correctly.
Grate for small cookware (fig. 2) Optional
This is placed only over the grate of the auxiliary burner (the smallest one) when using cookware with a small
diameter in order to prevent it from tipping over.
Special grate for WOKs (Fig. 3)
This is placed only over the grate of the triple crown burner when using a WOK (pan with concave bottom).
To avoid causing serious anomalies in the burner operation, it is recommended that you
do not use WO Ks
without this special grate and do not use the special grate for flat -bottom cookware.
46