Candy PC PSL 750 SX - Manual (Page 49)

INSTALLATION INSTRUCTIONS
Important!
These instructions are intended for a qualified installer.
The appliance must be installed correctly and in compliance with c urrent regulations.
Any work on
the appliance must be done with the appliance disconnected from the electrical power supply .
INSTALLATION :
Installation is completely chargeable to the buyer. The Manufacturing Company is exempt from this service.
Any operations requested from the Manufacturing Company as a result of incorrect installation are not
covered by the guarantee.
If the cooktop is being installed on an oven base, all the necessary precautions must be taken to ensure
installation in compliance w ith safety regulations (CEI - UNI - CIG). Pay particular attention that the electrical
cable and gas supply pipe are positioned so as to not come in contact with the hot parts of the oven casing.
Furthermore, if an oven without a cooling fan is installed u nder the cooktop, it is necessary to make openings
in the built-in unit to ensure proper air circulation. These openings must guarantee a free surface of at least
300 cm2 distributed as shown in figure 8.
Installation in the top (surface of the furniture )
The cooktop can be installed on all furniture, as long as it is heat resistant (withstanding temperatures up to
at least 90°C).
The dimensions of the hole to make on the furniture surface and the minimum distances from the back and
side walls and above
the appliance are indicated in figures 5 and 6.
Consider that:
When the cooktop is installed without an oven beneath, it is mandatory to use a dividing panel
between the bottom of the cooktop and the furniture underneath, at a minimum distance of 10 mm.
If the cooktop is matched with an oven, place a partition at a minimum distance of 15 mm, while
maintaining ventilation as specified in fig. 8.
In any case the electrical connection of the two appliances must be realized separately, both for electrical
reasons as well as to facilitate their extraction.
It is recommended that you use an oven with a forced cooling fan.
Fixing the cooktop
The cooktop must be fixed to the furniture as follows:
Position the appropriate sealing gasket provided with the co oktop along the external perimeter of the
hole made in the furniture according to the diagram in fig. 5, so that the ends of the strips are
perfectly joined to one another without overlapping.
Arrange the cooktop in the hole on the furniture, making sure that it is centered.
Fix the cooktop to the furniture with the appropriate brackets supplied with the cooktop as illustrated
in fig. 7.
Correct installation of the sealing gasket provides an absolute guarantee against the infiltration of liquids.
47