Candy PC PSL 750 SX - Manual (Page 51)

Electrical connection
The appliance must be connected to the mains power supply after verifying that the voltage corresponds to
the value indicated in the typeplate characteristics and that the sections of the electrical system cables can
support the load indicated on the typeplate.
The plug that is used for the connection must be up to standard and suitable for the power absorbed by the
appliance. If the appliance is to be connected directly to the mains, a n omnipolar switch must be placed
between the appliance and the mains which has a minimum opening distance of 3 mm between the
contacts, is suitably sized for the load and satisfies the relative standards.
Do not use reducers, adapters or shunting switch es for the connection to the mains, since
these may overheat and cause burnouts.
The earthing of the appliance is mandatory. The manufacturer declines all responsibility
resulting from failure to observe this rule. (Fig. 11)
If the power cord must be repl aced, use a cable having the same characteristics as that provided, suitable
for the load and temperature (type T90°C). This cable must be requested from the service centre. The end
that goes to the appliance must also have the Yellow -Green earth wire 20 m m longer than the others.
For the power cord dimensions, see the table below:
Type of cooktop Dimension
Only with gas burners 3 X 0.75 mm2 H05 V2V2 -F
THE MANUFACTURER DECLINES ALL RESPONSIBILITY IF THE INSTRUCTIONS ABOVE AND
RELEVANT SAFETY STANDARDS A RE NOT OBSERVED.
CLEANING
To keep your cooktop in good condition, it should be cleaned regularly after each use once it has cooled.
Never remove the knobs from their seats.
Enamelled parts
All enamelled parts must be washed only with a sponge and so apy water or using other non - abrasive
products made specifically for enamelled surfaces. After washing, dry thoroughly.
Stainless steel surface
The stainless steel surface should be cleaned with a damp cloth and specific products easily found on the
market.
After rinsing well, if possible, dry with a buckskin cloth.
Grates
The enamelled grates of the cooktop have been designed to be washed even in the dishwasher.
The stainless steel reducer may take on a bluish colouring in the burner area due to the te
mperature. This
effect may be attenuated using common stainless steel sponges available on the market.
Burners
The burners, composed of two pieces, can be removed and washed with suitable products. After cleaning,
they must be thoroughly dried and replac ed precisely on their seats.
With regard to the electric ignition, check that the electrode E (fig.12) is always clean.
Clean the probe T (fig.12) so as to allow regular operation of the safety valve. Both the electrode and the
probe must be cleaned with c aution. When finished, replace the burners precisely in their housing.
To prevent damage to the electric ignition, avoid using it when the burners are not in their seats.
49