Accusys ExaSAN A12S2-PS - Manual (Page 56)

4. How to Use
User Guide Page 4-5
4.1.2.1 Adding and Removing Controllers
In order to administer a controller, it first needs to be added to the network. Once
added, the administrator is given full control over the controller.
RAIDGuard X is a powerful GUI management system. It can be used for remotely
monitoring the RAID controller. If using the server to administer RAID configurations, you
must make sure that the RAID host and server are on the same network. The direct
attached storage client can also add or remove controllers in RAIDGuard X.
Adding
1. Click Add Controller to display a list of available controllers on the network. If the
ExaSAN RAID system is used as a DAS, the controller is displayed as “Local” under
the IP field.
2. Click on the controller to administer, enter the password. The default password for
the Accusys PCIe controllers is 00000000 (8 zeros).
3. Assign a name to the controller and click Add.
4. The Main screen lists the controller after it has been successfully added.
Note
To change the controller password, refer to Section 4.1.2.7.3
MISC.