Accusys ExaRAID GUI - Manual (Page 169)

Using the CLI Commands
4-38
Command beeper
Synopsis beeper on/off/mute
Description Review or set the beeper.
Command fwupdate
Synopsis fwupdate image.bin [-b] [-c ctlx]
Description
Upload the firmware image or update the boot code with
the file, image.bin.
Parameters
[-b]: update boot code
[-c ctlx] (for redundant controller only): target controller to
update
Command fwupdateprog
Synopsis fwupdateprog [-c ctlx]
Description List the current firmware update progress.
Parameters
[-c ctlx] (for redundant controller only): target controller to
get firmware update progress
Command batterylist
Synopsis batterylist ctlx
Description List the status of the battery installed in a controller.
Command ctldst
Synopsis ctldst on/off
Description
Enable or disable the detailed self test of controller during
start-up.
Command diagdump
Synopsis diagdump diag.bin [-p]
Description
Export extensive diagnostics information from the controller
to a file. This command only works on local CLI run on the
host computer and dosen’t work on remote CLI via telnet,
SSH, or RS232.
Parameters
[-p] Dump diagnostics of peer controller (for redundant
controller only)
Command nandflash
Synopsis nandflash primary/secondary
Description Show the current status of the on-board NAND flash chips.