Garmin G1000 Piper PA-46 Meridian - Manual (Page 38)

190-00763-01 Rev. A Garmin G1000 Pilot’s Guide for the Piper PA-46 Meridian 24
SYSTEM OVERVIEW
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
DFLTS Resets PFD to default settings, including changing units to standard
WIND Displays softkeys to select wind data parameters
OPTN 1 Headwind/tailwind and crosswind arrows with numeric speed components
OPTN 2 Wind direction arrow and numeric speed
OPTN 3 Wind direction arrow with headwind/tailwind and crosswind numeric speed
components
OFF Information not displayed
DME Displays/removes the DME Information Window (optional)
BRG1 Cycles the Bearing 1 Information Window through NAV1, GPS/ waypoint identifier
and GPS-derived distance information, and ADF/frequency.
BRG2 Cycles the Bearing 2 Information Window through NAV2 or GPS waypoint identifier
and GPS-derived distance information, and ADF/frequency.
ALT UNIT Displays softkeys for setting the altimeter and BARO settings to metric units
METERS When enabled, displays altimeter in meters
IN Press to display the BARO setting as inches of mercury
HPA Press to display the BARO setting as hectopacals
STD BARO Sets barometric pressure to 29.92 in Hg (1013 hPa if metric units are selected)
OBS Selects OBS mode on the CDI when navigating by GPS (only available with active
leg)
CDI Cycles through GPS, VOR1, and VOR2 navigation modes on the CDI
DME Displays the DME Tuning Window, allowing tuning and selection of the DME
(optional)
XPDR Displays transponder mode selection softkeys
XPDR1 Selects the #1 transponder as active
XPDR2 Selects the #2 transponder as active
STBY Selects standby mode (transponder does not reply to any interrogations)
ON Selects Mode A (transponder replies to interrogations)
ALT Selects Mode C – altitude reporting mode (transponder replies to identification and
altitude interrogations)
GND Manually selects Ground Mode, the transponder does not allow Mode A and
Mode C replies, but it does permit acquisition squitter and replies to discretely
addressed Mode S interrogations
VFR Automatically enters the VFR code (1200 in the U.S.A. only)
CODE Displays transponder code selection softkeys 0-7
0 — 7 Use numbers to enter code
BKSP Removes numbers entered, one at a time
IDENT Activates the Special Position Identification (SPI) pulse for 18 seconds, identifying
the transponder return on the ATC screen
TMR/REF Displays Timer/References Window
NRST Displays Nearest Airports Window
MSG Displays Messages Window