Hard drive, Removing the hard drive, Replacing the hard drive – Dell Latitude D531 User Manual
Page 22
Back to Contents Page
Hard Drive
Dell™ Latitude™ D531 Service Manual
Returning a Hard Drive to Dell
Removing the Hard Drive
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the two M3 x 3-mm hard drive screws.
3.
Slide the hard drive out of the computer.
Replacing the Hard Drive
1.
Remove the new drive from its packaging, if applicable.
Save the original packaging for storing or shipping the hard drive.
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
Do not touch the metal housing of the hard drive if you remove the hard drive from the computer while the drive is hot.
NOTICE:
To prevent data loss, turn off your computer before removing the hard drive. Do not remove the hard drive while the computer is on or in a
power management mode.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such
as the back panel on the computer.
NOTICE:
To avoid damaging the hard drive, handle the drive with care.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives obtained from sources other than Dell.
NOTE:
If you are installing a hard drive obtained from a source other than Dell, you may need to install an operating system, drivers, and utilities on the
new drive.
1
M3 x 3-mm screws (2)
2
hard drive
NOTICE:
When the hard drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge" in the
Product Information Guide).
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such
as the back panel on the computer.
NOTICE:
Use firm and even pressure to slide the drive into place. Excessive force may result in damage to the connector.