Replacing the mini-card – Dell Latitude D531 User Manual
Page 32
6.
Remove the Mini-Card from the connector at a 45-degree angle.
Replacing the Mini-Card
1.
Align the Mini-Card edge connector with the system board connector, then slide the card firmly into the connector at a 45-degree angle.
2.
Rotate the Mini-Card down until it clicks into place. If you do not feel the click, remove the card and reinstall it.
3.
Connect the cables to the Mini-Card, ensuring that you route the cables correctly.
4.
Replace the keyboard (see
Replacing the Keyboard
).
5.
Replace the hinge cover (see
Replacing the Hinge Cover
).
Back to Contents Page
1
Mini-Card
2
metal retention bracket
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such
as the back panel on the computer.
NOTICE:
The card connector is keyed to ensure correct insertion. If you feel resistance, realign the card.
NOTICE:
To avoid damaging the Mini-Card, never place cables on top of or under the card.
NOTICE:
Do not insert a Mobile Broadband (WWAN) network card into the WLAN card connector.
NOTE:
The Mini-Card may have two or three antenna connectors, depending on the type of card you ordered.
NOTE:
For more specific information about which cable to connect to which connector, see the documentation that came with your Mini-Card.