Dell Latitude D531 User Manual
Page 29
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Loosen the captive screw securing the memory module cover, then remove the cover and set it aside.
3.
Use your fingertips to carefully spread apart the metal clips securing each end of the memory module until the module pops up.
4.
Remove the memory module from the connector at a 45-degree angle.
Replacing a Memory Module
To remove a memory module, see
NOTICE:
If you leave the area, ground yourself again when you return to the computer.
1
captive screw
2
memory module cover
NOTICE:
To prevent damage to the memory module connector, do not use tools of any kind to spread the metal clips that secure the module.
1
memory module
2
metal retention clips (2)
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such
as the back panel on the computer.
NOTICE:
If you need to install memory modules in two connectors, install a memory module in DIMM A before you install a module in DIMM B.
NOTICE:
Insert memory modules at a 45-degree angle to avoid damaging the connector. If the memory module is not installed properly, the computer
may not boot. No error message is displayed to indicate this type of failure.
NOTE:
For optimal performance, identical memory modules should be used in each connector.