3 how to slip an element using the mouse, How to slip an element using the mouse, Ow to – EVS IPDirector Version 5.8 - July 2010 Part 7 User's Manual User Manual
Page 150: Lip an, Lement, Sing the, Ouse
IPDirector V.5.8 – User Manual – Part 7: Editing - IPEdit
EVS Broadcast Equipment – July 2010
Issue 5.8.B
137
4.10.3 H
OW TO
S
LIP AN
E
LEMENT
U
SING THE
M
OUSE
To slip one or more elements of the same source media using the mouse, proceed
as follows:
1.
Activate the slip mode on the requested elements by lassoing the whole
elements from right to left. See also section 4.10.2 ‘Activating and
Deactivating the Slip Mode’, on page 135.
Î
2.
Click the requested Timeline Track Selection buttons to select or unselect
the tracks you want or do not want to slip.
3.
Click the mouse on one of the elements in slip mode and drag it to the left
or right to slip the elements respectively to the left or to the right.
The TCs of the IN point and OUT point that correspond to the slip action
applied are displayed in the Timecode bar.
When you release the mouse, the slip action is applied within 1 sec.
4.
Click anywhere in the Lasso Selection area to leave the slip mode.