5 how to slip an element using the shuttlepro, How to slip an element using the shuttlepro, Ow to – EVS IPDirector Version 5.8 - July 2010 Part 7 User's Manual User Manual
Page 152: Lip an, Lement, Sing the, Huttle
IPDirector V.5.8 – User Manual – Part 7: Editing - IPEdit
EVS Broadcast Equipment – July 2010
Issue 5.8.B
139
4.10.5 H
OW TO
S
LIP AN
E
LEMENT
U
SING THE
S
HUTTLE
PRO
To slip one or more elements of the same source media using the ShuttlePRO,
proceed as follows:
1.
Activate the slip mode on the requested elements by lassoing the whole
elements from right to left. See also section 4.10.2 ‘Activating and
Deactivating the Slip Mode’, on page 135.
Î
2.
Click the requested Timeline Track Selection buttons to select or unselect
the tracks you want or do not want to slip.
3.
Rotate the jog to the left or to the right to slide the elements respectively to
the left or to the right.
When you stop turning the jog, the slip action is applied within 1 sec.
4.
Click anywhere in the Lasso Selection area to leave the slip mode.