Adjusting the audio volume on the timeline, Introduction, Accessing and leaving the volume automation mode – EVS IPDirector Version 6.0 - November 2012 Part 8 User's Manual User Manual
Page 205: Overview of the possible actions, Audio volume automation panel, Overview
6.14.
Adjusting the Audio Volume on the
Timeline
6.14.1. Introduction
You can adjust the audio volume for each track, i.e. group of audio channels, of a timeline
by means of the Volume Automation mode.
Note
You cannot use the volume automation feature on timeline elements whose
speed is different than 100%.
6.14.2. Accessing and Leaving the Volume
Automation Mode
•
To access the Volume Automation mode on a given track of the loaded timeline, click
the Volume Automation button
on the right of the track display.
•
To leave the Volume Automation mode, click the
button.
6.14.3. Overview of the Possible Actions
In the Volume Automation mode, you can perform the following actions:
•
Increase or decrease the global audio volume of a track
•
Increase or decrease the volume of a part of a track
•
Modify the audio level on a given position of a track
•
Reset the audio volume of a whole audio track
•
Reset the audio volume of the audio track of a given element
6.14.4. Audio Volume Automation Panel
Overview
The Audio Volume Automation panel contains the main areas highlighted on the following
screenshot and shortly described in the table below.
IPDirector - Version 6.00 - User Manual - IPEdit
6. Timeline
193