Hotchkis 22813 Volkswagen MKIV Sport Sway Bars User Manual

Installation of hotchkis front sway bar

Advertising
background image



Sport Sway Bar Kit 22813

VW Golf GTI, Jetta 5/6 Speed & Automatic

Thank you for your purchase from our new line of VW parts.

Please call us at (877) 4NO - ROLL if you have any questions

regarding the service or installation of your Hotchkis products.

(For full size instructions in pdf format, please visit our website at

www.hotchkis.net

)


Tools required for this installation:
-

4-post lift with roller jacks or tranny jack

-

The following sockets or wrenches: 12mm, 13mm, 14mm, 16mm, 17mm, 21mm, 5/8”, 11/16”

-

The following Allen wrenches: 6mm

-

Suggested tools: 6” socket extension, swivel ratchet

Hotchkis HIGHLY recommends that this sway bar set be installed by a professional, as the front sway

bar can only be removed or installed by detaching the front subframe cradle and lowering it from the

vehicle!

INSTALLATION OF Hotchkis FRONT SWAY BAR


»

Drive the vehicle on a 4-post lift. Securely block the rear wheels of the vehicle. Use jack to lift up the
front of the vehicle. Do not remove the front wheels during installation for safety.


»

Remove plastic splashguard underneath the engine.


»

Take a minute and observe underneath the front of the vehicle. The front sway bar is inconveniently
located in between the subframe cradle and engine. In order to remove the front sway bar, you will be
required to detach the front subframe cradle from the chassis. The subframe does NOT support the
engine, so you don’t have to worry about the engine falling on you once the subframe is loose.

Advertising
Table of contents