Hotchkis 2285 C5 Corvette Sport Sway Bar Set w-o end links - Manual

1 of 9
C-5 Corvette Sway Bar Installation
P/N 2234 w/ Adjustable Rear Bar
Please look at the installation of the factory sway bar package before you install
your new Hotchkis 2285 Sport Sway Bar Set.
Tools Needed for Installation:
T-40 Torx Driver, 5mm (or 3/16”) allen wrench, 13-19mm sockets, ratchet
wrench, 16-19mm combination wrench , Lock-Tite and Anti-Seize compound.
This kit is intended for Corvettes with OEM metal end links. If your car is
equipped with composite end links, please replace them with the C5/C6 OEM
metal end links.
Front Bar Installation:
Make sure you use proper safety devices such as jacks stands and/or jacks to
avoid possible injury.
1.
Using a 18mm combo wrench and a T-40 torx driver & ratchet, remove the
lower end link nut. Use a spray lubricant to help in removal
2. Remove the four bolts holding the front sway bar to the frame. Use a
15mm socket ratchet and extension.
3.
Once you disconnect everything
pop the lower end link stud out
of the holes, slide the bar side-
ways and twist it out of the
vehicle.
1 2
3