Hotchkis 22822 Audi A6 Sport Sway Bar Set Black - Manual (Page 3)

7/
Repeat same pressure to the exhaust and position Hotchkis bar (without
the bushings and brackets) in the stock location with the “HSport” sticker facing
rearward, right side up.
8/
Apply supplied grease to inner-channeled portion of both rear bushings.
(approx. quarter tube per bushing; picture on next page) Then install the
bushings to the bar at approx. the stock locations. Position the bar in the stock
location then install the brackets over the bushings with the grease fittings
pointed down.
9/
Re-install the end link bolts and nuts and leave loose. Secure the bushing
brackets. Tighten the four bracket bolts, then tighten the end link bolts.
VERY IMPORTANT!!! Make sure the end links are outboard of the sway bar
ends. This is usually apparent when the car is properly installed on a 4-
post lift or ramps. They are easily installed incorrectly
when using a 2-post
lift with the suspension drooping down! Make sure you or your mechanic
is aware of this. Damage to your shocks and/or end links will occur if
installed incorrectly. Please see the following pictures for more detail.