MSD 2910 Atomic EFI Master Kit Installation - Manual (Page 11)

INSTALLATION INSTRUCTIONS 11
M S D
• W W W . A T O M I C E F I . C O M • ( 9 1 5 ) 8 5 5 - 7 1 2 3 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
Figure 10 Atomic Wiring with an MSD Ignition Control.
GREEN (-) VIOLET (+)
ECT
SENSOR
REV
LIMITER
DIGITAL 6AL
WHITE
ORANGE TO AC INPUT
WHITE
YELLOW
NOT USED
ORANGE
BLACK
MAG PICKUP
NOT USED
Orange (+) and Black (-)
are the only wires that
connect to the coil.
GRAY
*Do NOT connect the small Red wire to the coil (+)
terminal when using an MSD Ignition or other CD
ignition control.
PINK - FAN 2 PROVIDES GROUND
TAN - FAN 1 PROVIDES GROUND
RED - IGNITION SWITCHED 12V
*
FUEL
PUMP
BLACK - GROUND
HEAVY RED - BATTERY
O2
SENSOR
BLACK
GROUND
HEAVY ORANGE
RED - IGNITION SWITCHED 12V
INDICATES CONNECTION
TO 12V
IGNITION
KEY
TO NITROUS 12V
ACTIVATION WIRE
NOT
USED
STOP HERE
Please review the parts installed thus far. Check to see that all required wires are run properly and
that the fuel system is complete and secure. The next section of instructions will require power to the
Handheld. Turning on power (Key On) will prime the fuel pump. It is extremely important to check for
fuel leaks at this time.
Do not attempt to start the engine until the Initial Setup has been completed on the Handheld.