Ohaus AP250E ANALYTICAL Plus Electronic Balances - Manual (Page 62)

62
Initialize Initialize Initialize Initialize Initialize
This submenu allows you to:
•
Specify a time interval (in seconds) for automatic output.
•
Exclude a range of weights from being output, or specify a range for output, by the
Auto Print feature.
It does not appear on the Print menu if Auto Print is set to OFF. Use the following
procedure to set these features:
1. Access the submenu under the Print Options submenu.
2. displays if Interval was selected in the Auto
Print submenu and you may continue with step 3. If interval was not selected,
is displayed. Proceed to step 7.
3. to enter time interval for automatic data output.
The current interval from to
(in seconds) is displayed.
4. to increase or to decrease the interval number.
5. .
6. to enter a range of non printing values.
7. , the
current value for the low end of the
range is displayed with the first digit
flashing.
8. to change the number,
start with the first digit (flashing).
Change the value to any number from
-9 to +9. A minus sign will light to
indicate a negative value.
9. to accept it and the next digit
will begin flashing.
10.Set all digits in the same manner. If an error is made, to backup to
the desired digit and change it.
To exclude data To exclude data To exclude data To exclude data To exclude data
WITHIN SELECTED RANGE:
WITHIN SELECTED RANGE: WITHIN SELECTED RANGE: WITHIN SELECTED RANGE: WITHIN SELECTED RANGE:
SET non-PL < non-PH
Example:non-PL=7g, non-PH=11g
Values <7 OR OR OR OR OR >11 will be output.
To exclude data To exclude data To exclude data To exclude data To exclude data
OUTSIDE SELECTED RANGE:
OUTSIDE SELECTED RANGE: OUTSIDE SELECTED RANGE: OUTSIDE SELECTED RANGE: OUTSIDE SELECTED RANGE:
Set non-PL > non-PH
Example:non-PL=11g, non-PH=7g
Values >7 AND AND AND AND AND <11 will be output.
MENUS