Ohaus MB35 MOISTURE ANALYZER Manual fr - Manual (Page 21)

MB35 EN-19
5.4 Accessories
Description Ohaus Part No.
Span Calibration Mass 20 g ASTM Class 1 Tolerance 80780022
Security Locking Cable 80850043
RS232 Interface Cable, 9 pin serial extension - PC to MB45 80500525
RS232 Interface Cable, MB35 to printer (25 pin) SF42 80500571
Data Printer SF42
Sample Pans 90mm diameter 80850086
Glass Fiber Pads 80850087
Pan, Re-usable - 90mm (set of three) 80850088
In-use Cover 80850085
Temperature Calibration Kit 11113857
Pan Handler 11113873
5.5 Specifications
Model MB35
Capacity 35g
Readability 0.002g, 0.02%
Temp. Settings 50°C to 160°C (5° increments)
Drying Programs Standard
Switch-off Criteria Timed, Auto
Heat Source Halogen
Calibration External calibration mass-20g
Dimensions (DxWxH) (cm) 35.5 x 19 x 15.2
Pan Size 90 mm. diameter
Weight (kg) 4.5
Shipping Weight (kg) 6.4
Admissible ambient conditions
Indoor use only
Altitude:
Up to 2000m
Temperature range: 5 ºC to 40 ºC
Atmospheric humidity: Maximum relative humidity 80% for temperatures up to 31 °C
decreasing linearly to 50% relative humidity at 40 °C.
Warm-up time: At least 60 minutes after connecting the instrument to the
power supply; when switched on from standby-mode, the
instrument is ready for operation immediately.
Voltage fluctuations: Mains supply voltage fluctuations up to –15% +10% of the
nominal range
Over voltage category: II
Pollution degree: 2
Power load: Max. 450 W during drying process
Current consumption: 4 A or 2 A, according to the heating element
Power supply voltage: 100 V – 120 V or 200 V – 240 V, 50/60 Hz
(the voltage is given by the heating element)
Power line fuse: 1 piece, 5 x 20 mm, T6,3 H 250 V