Ohaus MB35 MOISTURE ANALYZER Manual fr - Manual (Page 8)

EN-6 MB35
2.5 Operating Controls
The MB35 Moisture Analyzer controls are grouped as operating buttons and function buttons with three
modes of operation.
EDIT MODE – User is changing a
parameter, no test running.
RUN MODE – Unit is running a test.
RESULT MODE – Final result.
OPERATING BUTTONS
Turns display On or Off.
Press to enter ANALYZER SETUP screen. (Edit mode)
Print Test Result (if COM parameters are set and PRINT is on).
Accepts selection. (Edit mode) Sends Print command. (Run mode)
Performs Tare function. (Pressing during the test has no effect.)
FUNCTION BUTTONS
EDIT MODE
ONLY
100 ° 10:00
CLEAR
PAN
PRESS
TARE
0.000g
*
Initial press of button highlights tempera-
ture numerals. Additional presses
increases temperature setting in 5 degree
increments.
EDIT MODE
ONLY
100 ° 10:00
CLEAR
PAN
PRESS
TARE
0.000g
*
Initial press of button highlights shut-off
selection. Additional presses step through
options, AUTO or TIMED
(minutes/seconds).
EDIT MODE
ONLY
ANALYZER SETUP
WEIGHT CAL
TEMP CAL
TIME-DATE
RS-232
PRINT
EXIT
In a non-run mode, initial press of button
brings up the ANALYZER SETUP screen.