Shogun Motorsports Suzuki GSXR600_750 (2008) Frame Slider - Manual (Page 3)

With the body removed, thread in by hand your spot tool. Make sure you have the spot tool
screwed in enough to clear the body on the inside.
7.
Loosely mount your bodywork and adjust the spot tool out to lightly touch the inside of the
body. Make sure you have at least 15mm of thread engagement, without that the spot tool will
tend to sag down giving you a false location. With the body mounted in the correct location use
a soft micro fiber cloth over the spot tool location and softly tap to leave a spot mark on the
inside of the body. Be careful not to scratch or chip the body.
8.
Remove the bodywork and double check location of spot mark the tool has created.
9.
Using a small drill ¼ inch or so drill a pilot hole in the body from the inside out. Remount
bodywork and double check the hole location with the spot tool still inserted (arrow in picture
below is pointing to spot tool). With pilot hole cut and on center, remove body and disassemble
panel to prep for cutting.