Shogun Motorsports Yamaha FZ6R (09-13) Frame Slider - Manual (Page 3)

6.
Remove the bodywork and double check location of spot mark the tool has created.
7.
Using a small drill ¼ inch or so drill a pilot hole in the body from the inside out. Remount
bodywork and double check the hole location wi
center, remove body panel to prep for cutting.
8.
Body Prep. Use masking tape to completely mask off the area on the body where you will be
working. We usually will tape off approximately 6 to 8 i
other edges that could get bumped or scratched while working. Tip: In some locations you may want to
double up the thickness of the masking take to give extra protection.
Remove the bodywork and double check location of spot mark the tool has created.
Using a small drill ¼ inch or so drill a pilot hole in the body from the inside out. Remount
bodywork and double check the hole location with the spot tool still inserted. With pilot hole cut and on
center, remove body panel to prep for cutting.
Body Prep. Use masking tape to completely mask off the area on the body where you will be
working. We usually will tape off approximately 6 to 8 inches around the though hole area and any
other edges that could get bumped or scratched while working. Tip: In some locations you may want to
double up the thickness of the masking take to give extra protection.
Remove the bodywork and double check location of spot mark the tool has created.
Using a small drill ¼ inch or so drill a pilot hole in the body from the inside out. Remount
. With pilot hole cut and on
Body Prep. Use masking tape to completely mask off the area on the body where you will be
nches around the though hole area and any
other edges that could get bumped or scratched while working. Tip: In some locations you may want to