Shogun Motorsports Yamaha FZ6R (09-13) Frame Slider User Manual
Page 4
9.
For this application we used a Dremel tool with a sanding roll to open up the hole little by
little.
MAKE SURE YOU WEAR PROTECTIVE GOGGLES AND GLOVES
As you cut and open the hole to your
scribe marks keep checking that the hole is lining up with your puck dimensions or the spot tool. If for
some reason you cut too big and you want to close the gap around the puck we use windscreen trim or
window seal with 3m adhesive. Trim the seal to fit the hole and get the seam to meet under the puck so
it is less visible.
10.
Mount left side panel.
11.
Mount left side puck with 99-HB-SH101250110 Socket Cap 10 X 1.25 X 110 Main Engine Stud
and torque down.
12.
Repeat all installation steps for the right side.
READ CAREFULLY
Shogun cannot guarantee that they will protect your motorcycle from any extent of damage.