Shogun Motorsports Yamaha R6S (06-09) NO CUT Frame Slider User Manual
Page 2
2.
Remove the left side engine stud. Mount the left side offset using 99-HB-SH10125060 Socket
Cap 10 x 1.25 x 60 Main Engine Stud. Tip: Only tighten enough so you can still move the offset
by hand. Loosely mount the left side body panel. Adjust the offset so the frame slider when
mounted will clear the body work. Loosely mount the puck, adjust offset by hand to where the
puck is about ½ inch from touching the bodywork. Note: There is a radius in the body opening
(where the puck comes through) it is located right below where the main engine stud is. The
puck (frame slider) should sit in the center of that radius about a ½ inch away from the body
work.
3.
Remove the loosely mounted puck and body panel. With the offset in the correct position
torque down to OEM torque specs
4.
Using one drop of blue (medium) thread locker mount the left side puck to the offset using the
99-HB-SH10150035 Socket Cap 10 x 1.5 x 35. Torque down to 30 to 32 foot lbs.
5.
Remove the right side engine stud. Mount the right side offset using 99-HB-SH10125050 Socket
Cap 10 x 1.25 x 50 Main Engine Stud. Tip: Only tighten enough so you can still move the offset
by hand. Loosely mount the right side body panel. Adjust the offset so the frame slider when
mounted will clear the body work. Loosely mount the puck, adjust offset by hand to where the
puck is about ½ inch from touching the bodywork. Note: There is a radius in the body opening
(where the puck comes through) it is located right below where the main engine stud is. The
puck (frame slider) should sit in the center of that radius about a ½ inch away from the body
work.
Make sure the puck is lined up in the same location as the left side.
6.
Remove the loosely mounted puck and body panel. With the offset in the correct position
torque down to OEM torque specs
7.
Using one drop of blue (medium) thread locker mount the left side puck to the offset using the
99-HB-SH10150035 Socket Cap 10 x 1.5 x 35. Torque down to 30 to 32 foot lbs.
8.
Remount body work.