Veris Technologies MSP EC and pH (1997-2008 floppy disk drive 1.02E) - Operating Instructions - Manual (Page 15)

Veris Technologies
Pub. #OM MSP03-1
15
machine (Fig. 3.1). Maintain the hydraulic fluid within 1/2 inch of the upper (solid black) line on the
glass. Remove the threaded plug from the filler neck (Fig 3.1) to add fluid.
• Escaping fluid under pressure can penetrate the skin causing serious injury. Avoid the hazard by
relieving pressure before disconnecting hydraulic lines. Use a piece of paper or card-board, NOT
BODY PARTS, to check for suspected leaks.
• Wear protective gloves and safety glasses or goggles when working with hydraulic and high-
pressure wash systems.
• If an accident occurs, see a doctor immediately. Any fluid injected into the skin must be surgically
removed within a few hours or gangrene may result.
Field Operations—Soil EC Surveyor
Checking Electrical Signal Continuity and Electrode Isolation
It is recommended that you routinely check the EC signal to verify that all functions are working
properly. See Maintenance and Lubrication Section for a step-by-step procedure. It is advisable to
perform this test on a routine basis (weekly or every 20-25 hours of data collection) to ensure you are
obtaining reliable data.
Setting Operating Depth
Begin field operation by lowering unit into soil. For good electrical conductivity, all coulter electrodes
must be in direct contact with the soil, at all times and in every region of the field. A depth of 1-2”
(2.5-5 cm) is recommended. To insure this depth is consistently achieved, 400-600 lbs. (180-275 kg)
of additional weight are normally required. Veris offers optional weights, or they can be supplied by
the customer. If the unit is equipped with the pH module, keeping 40-60 gallons (225-350 L) of water
in the tanks provides ballast. Do not adjust the tension on the coulter electrode springs to increase
soil contact or penetration. They are pre-set at the factory with the proper tension. If unit is equipped
with pH module, it is especially important to keep the implement level during field operation. Adjust
top link to level.
hydraulic oil filler plug
hydraulic oil
sight glass