VTech CS6829 Manual - Manual (Page 25)

21
Telephone operation
Volume
During a call, press /VOLUME or /VOLUME to adjust
the listening volume.
When the volume reaches the minimum or maximum setting,
you hear two beeps.
The handset earpiece and speakerphone volume settings
are independent.
Mute
The mute function allows you to hear the other party but the other party cannot
hear you.
During a call, press MUTE. The handset displays Muted until
the mute function is turned off.
Press
MUTE again to resume the conversation. The handset
displays Microphone on briefly.
Call waiting
When you subscribe to call waiting service from your telephone service provider, you
hear an alert tone if there is an incoming call while you are already on another call.
Press FLASH to put the current call on hold and take the new call.
Press FLASH at any time to switch back and forth between calls.
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the handset
or telephone base without disconnecting the call. The next call rings normally at the
preset volume.
To silence the handset ringer:
Press OFF or MUTE, then displays and Ringer muted
displays briefly.
To silence the telephone base ringer:
Press VOL-.
Each handset and the base ring when there is an incoming call unless
the ringer volume of that device is turned off.
•
•
•
•
•
•
Ringer muted
ECO
Muted
ECO
ANS ON
10:15
PM
12/18
ANS ON
10:15
PM
12/18