VTech CTM-S242SD Manual - Manual (Page 38)

34
Installation option - converting from desktop to wall mount position
This telephone can be adapted to desktop use or mount on a standard telephone wall plate.
To mount the telephone base on the wall:
Unplug the Cat-5 network cable from the network wall jack.
Remove the cordless handset from the telephone base cradle. On the telephone base, place a coin in the slit of the wall mount
clip and rotate a half turn (180 degrees). It locks into place with the protruding edge pointing towards the upper edge of the
telephone base. This protruding edge holds the cordless handset when the phone is mounted on the wall.
Turn the telephone base over with the bottom side facing up. To remove the mounting bracket, press the tabs of the mounting
bracket in the direction indicated below to release and remove it from the telephone base.
Rotate the mounting bracket. Insert the tabs of the mounting bracket into the middle grooves on the telephone base as shown
below. Then press the tabs and push the mounting bracket into the lower grooves on the telephone base until they lock securely.
Mount the telephone base on the wall by aligning the eyelets with the mounting studs of the wall plate. Then slide the telephone
base down on both mounting studs until it locks into place.
Plug the Cat-5 network cable back in the network wall jack with Power over Ethernet (PoE). Then place the cordless handset on
the telephone base cradle.
1.
2.
3.
4.
5.
6.
SIP classic cordless 1-line/2-line - S1410/S1420
Installation
Protruding edge
Eyelets
Mounting
bracket