VTech CTM-S242SD Manual - Manual (Page 74)

70
SIP contemporary cordless 1-line - S2410/CTM-S2411
Using the cordless handset and the telephone base
The cordless handset and the telephone base cannot be used on the same call. However, calls can be switched between the
cordless handset and the telephone base speakerphone.
When the cordless handset or the telephone base is in use, the
TALK key on the cordless handset and the LINE key on the
telephone base illuminate.
Receive a call
When there is an incoming call, the telephone rings. The LINE key and the MESSAGE WAITING LED on the telephone base flash,
and the TALK key on the cordless handset flashes.
To answer a call using the cordless handset while it is not on the telephone base, charging base or charging stand:
On the cordless handset, press TALK or /SPEAKER. The TALK key illuminates when phone line is in use. The /SPEAKER key
illuminates when in speakerphone mode.
To answer a call using the cordless handset while it is cradled on the telephone base, charging base or charging stand:
Lift the cordless handset from the telephone base, charging base or charging stand. The
TALK key illuminates when the phone line
is in use. The /SPEAKER key illuminates when in speakerphone mode.
To answer a call using the telephone base:
On the telephone base, press
LINE or /SPEAKER. The LINE key illuminates when the phone line is in use. The /SPEAKER key
illuminates when in speakerphone mode.
Place a call
To place a call using the cordless handset:
On the cordless handset, press
TALK or /SPEAKER. Listen for a dial tone and then dial the desired number. The TALK key
illuminates when the phone line is in use. The /SPEAKER key illuminates when in speakerphone mode.
To place a call using the telephone base:
On the telephone base, press
LINE or /SPEAKER. Listen for a dial tone and then dial the desired number, or press a Speed Dial
key to dial a programmed number. The LINE key illuminates when the phone line is in use. The /SPEAKER key illuminates when
in speakerphone mode.
End a call
To end a call when using the cordless handset:
Press
OFF on the cordless handset or place it in the telephone base, charging base or charging stand. The call ends when all
handsets hang up.
To end a call when using the telephone base:
Press
LINE or /SPEAKER.
Switch a call between the cordless handset and the telephone base speakerphone
To switch a call from the cordless handset to the telephone base speakerphone, press /SPEAKER on the telephone base.
To switch a call from the telephone base speakerphone to the cordless handset which is not on the telephone base cradle,
press TALK or /SPEAKER on the cordless handset.
To switch a call from the telephone base speakerphone to the cordless handset which is cradled on the telephone base, lift the
cordless handset from the telephone base.
Share a call
During a call, another handset can join the call by pressing TALK or /SPEAKER.
Handset speakerphone
During a call, press /SPEAKER on the cordless handset to switch between speakerphone mode and handset earpiece mode.
Redial
The last dialed number on the cordless handset or the telephone base is stored for 15 minutes.
To redial the last dialed number from the cordless handset:
Press
TALK or /SPEAKER to listen for a dial tone. Then press REDIAL.
To redial the last dialed number from the telephone base:
Press
LINE or /SPEAKER to listen for a dial tone. Then press REDIAL.
•
•
•
Telephone operation