VTech CTM-S242SD Manual - Manual (Page 79)

75
Telephone operation
SIP contemporary cordless 2-line - S2420/CTM-S2421
Telephone operation
Redial
The last dialed number on the cordless handset or the telephone base is stored for 15 minutes.
To redial the last dialed number:
Press LINE 1, LINE 2 or /SPEAKER. Listen for a dial tone. Then press REDIAL.
Volume
Listening volume can be adjusted on the cordless handset and the telephone base.
To adjust the listening volume:
During a call on the handset, press -/VOLUME/+ on it to adjust the listening volume. The next call returns to the default
listening volume.
During a call on the telephone base, press
+/VOLUME or -/VOLUME on it to adjust the listening volume. The next call returns to
the default listening volume.
Ringer volume of the telephone base can be adjusted.
To adjust the ringer volume of the telephone base:
When the telephone base is idle, press
+/VOLUME or -/VOLUME on it to adjust the ringer volume .
Call waiting
Call waiting supports 2-line phones configured as single SIP account only. To change the SIP account settings, refer to the
SIP Phone Configuration Guide for details.
When you hear a call waiting tone during a call, press the corresponding line key to put the current call on hold and take the new
incoming call.
Press the corresponding line key at any time to switch back and forth between calls.
Message waiting indicator (only for line 1)
When a voice message is received, the MESSAGE WAITING LEDs on the telephone base and handset flash.
Mute
To mute the microphone:
During a call, press MUTE on the cordless handset or the telephone base. The MUTE lights turns on when the mute function is
turned on. You can hear the party on the other end but they cannot hear you.
Press
MUTE again to resume the conversation. The MUTE light turns off.
Hold
During a call, press HOLD on the cordless handset or the telephone base to place that call on hold. The corresponding line key
flashes when the call is on hold.
Press the flashing line key or
/SPEAKER to release the call from hold, or the call will end automatically after the preset call on
hold duration. When both lines are on hold, press /SPEAKER only releases the call from hold on line 1.
Intercom (for S2420 only)
Use this feature for conversations between two cordless handsets, or a cordless handset and the telephone base.
To initiate an intercom call:
On the cordless handset, press INTERCOM when it is not in use. It beeps and the INTERCOM key illuminates. All destination
cordless handsets and the telephone base ring. The INTERCOM keys on other cordless handsets and INT key on the telephone
base flash.
-OR-
On the telephone base, press INT when it is not in use. It beeps and the INT key illuminates. All destination cordless handsets
ring and the INTERCOM keys flash.
To initiate an intercom call during a call:
During a call on the cordless handset, press HOLD to put the current call on hold. Then press INTERCOM. It beeps and the
INTERCOM key illuminates. All destination cordless handsets and the telephone base ring. The INTERCOM keys on other
cordless handsets and INT key on the telephone base flash.
-OR-
During a call on the telephone base, press HOLD to put the current call on hold. Then press INT. It beeps and the INT key illuminates.
All destination cordless handsets ring and the INTERCOM keys flash.
•
•
1.
2.
1.
2.
1.
2.
•
•
•
•