VTech CTM-S242SD Manual - Manual (Page 75)

71
Telephone operation
SIP contemporary cordless 1-line - S2410/CTM-S2411
Telephone operation
Volume
Listening volume can be adjusted on the cordless handset and the telephone base.
To adjust the listening volume:
During a call on the handset, press -/VOLUME/+ on it to adjust the listening volume. The next call returns to the default
listening volume.
During a call on the telephone base, press
+/VOLUME or -/VOLUME on it to adjust the listening volume. The next call returns to
the default listening volume.
Ringer volume of the telephone base can be adjusted.
To adjust the ringer volume of the telephone base:
When the telephone base is idle, press
+/VOLUME or -/VOLUME on it to adjust the ringer volume .
Call waiting
When you hear a call waiting tone during a call, press FLASH on the cordless handset or the telephone base to put the current
call on hold and take the new incoming call.
Press
FLASH at any time to switch back and forth between calls.
Mute
To mute the microphone:
During a call, press MUTE on the cordless handset. The MUTE light turns on when the mute function is turned on. You can hear
the party on the other end but they cannot hear you.
Press
MUTE again to resume the conversation. The MUTE light turns off.
Message waiting indicator
When a voice message is received, the MESSAGE WAITING LEDs on the telephone base and handset flash.
Hold
To place a call on hold on the cordless handset:
During a call, press HOLD on the cordless handset. The TALK key on the cordless handset and the LINE key on the telephone
base flash when the call is on hold.
Press
TALK or /SPEAKER to release the call from hold, or the call will end automatically after the preset call on hold duration.
To place a call on hold on the telephone base:
During a call, press HOLD on the telephone base. The TALK key on the cordless handset and the LINE key on the telephone
base flash when the call is on hold.
Press
LINE /SPEAKER to release the call from hold, or the call will end automatically after the preset call on hold duration.
Intercom (for S2410 only)
Use this feature for conversations between two cordless handsets, or a cordless handset and the telephone base.
To initiate an intercom call:
On the cordless handset, press INTERCOM when it is not in use. It beeps and the INTERCOM key flashes. All destination
cordless handsets and the telephone base ring. The INTERCOM keys on other cordless handsets and INT key on the telephone
base flash.
-OR-
On the telephone base, press INT when it is not in use. It beeps and the INT key flashes. All destination cordless handsets ring
and the INTERCOM keys flash.
To initiate an intercom call during a call:
During a call on the cordless handset, press HOLD to put the current call on hold. Then press INTERCOM. It beeps and the
INTERCOM key illuminates. All destination cordless handsets and the telephone base ring. The INTERCOM keys on other
cordless handsets and INT key on the telephone base flash.
-OR-
During a call on the telephone base, press HOLD to put the current call on hold. Then press INT. It beeps and the INT key
illuminates. All destination cordless handsets ring and the INTERCOM keys flash.
•
•
1.
2.
1.
2.
1.
2.
1.
2.
•
•
•
•