Vutec ARTSCREEN Recessed Hook - Installation Instructions - Manual

INSTALLATION INSTRUCTIONS (rev A)
Recessed Mount Plasma
Installation
The Plasma must be in the vertical position for the Art
Screen to work properly. Tilting of the Plasma is not
recommended.
Referring to the table in this manual; determine the wall
opening height and width.
Review Figures 6 through 7 for a set of possible installation
scenarios.
Dry wall installation requires base support as shown in
Figure 1. Additional supports to strengthen the base support
should also be considered.
Determine ventilation concept for the plasma.
Determine I/O routing of the video/audio cables and AC power
supply.
Place the main shell in the wall opening. Be sure the main shell
is level; shims as required. Screw the shell to the wall.
Remove the Clamp Bar and the plasma stands.
Install the stands to the plasma. Place the fender washers in the
channel to reduce slot size for tightening of the screws.
Do not tighten the screws. Place the plasma with the
stands inside the main shell. Adjust the bottom rests to
center the plasma in the vertical direction.
Bring the plasma and it stands outside of the shell;
tighten the screws to secure the plasma to the stands.
Place the plasma back inside the shell. Make all
necessary connections, i.e. video/audio cables, AC
supply, etc.
Install the Clamp Bar. Do not tighten the screws.
Referring to Figure 4, position the plasma so that the
bezel face of the plasma is approximately 1/2 to 5/8
inch behind the shell. This is the clearance required
for the Artwork to travel up and down.
The plasma must be centered in the shell on all sides. Verify
and adjust as necessary. Tighten the screws of the Clamp
Bar to secure its location.
It is wise to test the complete system at this time.
Finish the gaps between the main shell and the wall as
required.
Figure 2
Main Shell Assembly
Figure 1
Wall Construction
VUTEC CORPORATION
www.vutec.com
TEL: (954) 545 9000 - FAX: (954) 545 9011
E-MAIL:[email protected]