Vutec ARTSCREEN Recessed Hook - Installation Instructions - Manual (Page 6)

PICTURE FRAME INSTALLATION & REMOVAL
WITH SLIDING CLIPS
The backside of the picture frame is in full contact with the front edges of the metal frame. Position the two corner woods and clips to
be guided by the vertical edges of the metal frame. Carefully pushes down (Figure C2) on the picture frame to set it in place. Corner
woods will make slight noise when they are bottom out to the metal frame. Push up picture frame (2 inches approx.) to remove.
A SPDT switch is provided for security connection (optional). Contact rating: 10A, 1/2HP, 125/250VAC or 6A, 30VDC
Figure A
Installed unit without picture frame
Figure B
Backside of picture frame
Figure C2
Picture frame pushes down
Figure C3
Clip fully engaged
Figure C1
Frame clip and ear prior to engagement
VUTEC CORPORATION
www.vutec.com
TEL: (954) 545 9000 - FAX: (954) 545 9011
E-MAIL:[email protected]