Vutec ARTSCREEN Recessed Hook - Installation Instructions - Manual (Page 8)

DISPLAY PANEL REAR VIEW
DISPLAY PANEL WALL INSTALLATION
ASSEMBLY INSTRUCTION (LCD SLIM LINE 1 1/2" PANEL DEPTH)
1. PLACE THE PANEL FACE DOWN ON A CLEANED AND FLAT SURFACE
LINEUP THE CLAMP BAR SLOTS WITH THE MOUNTING HOLES ON
REAR OF THE DISPLAY PANEL, ADJUST AS REQUIRED
2. SECURE THE CLAMP TIE BAR (HARDWARE NOT SUPPLIED) DO NOT OVER TIGHTEN
ROTATE THE ASSEMBLY UPRIGHT POSITION AND CHECK FOR PROPER
ALIGNMENT AND ADJUST AS NECESSARY.
3. REPLACE EXISTING IEC POWER CORD WITH THE (VUTEC SUPPLIED) NEMA 5-15
ROTATING UNIVERSAL IEC POWER CORD PRIOR TO PROCEEDING TO INSTALL
THE LCD DISPLAY
4. THE LCD DISPLAY SHOULD BE EQUALLY SPACED WITHIN THE INTERNAL FRAME PERIMITER
LINEUP THE TIE CLAMP MOUNTING SLOTS WITH THE APPROPRIATE THREADED
HOLE AS ILLUSTRATED BELOW AND FASTED WITH USING SUPPLIED HARDWARE.