GLOBALSAT TR-206 - Manual (Page 46)

45
6.2 Periodic Mode
Periodic mode is for setting an interval for TR-206 to regularly report its location
according to the interval. When it reaches the report time, TR-206 will turn on
GPS and GPRS connection and report the location and concerning information
to server. After sending the information, TR-206 will disconnect from server.
You can also set a traveled distance, and then TR-206 will report by the
combination of report interval and traveled distance, depending on which
criterion is reached first. If checking traveled distance is needed, you have to
extra make GPS on. Please refer to “Chapter 4 GPS.”
For example, the report interval is 60 seconds, the traveled distance is 800
meters, TR-206 sends 1 report at 10:00:00, and then it detects the traveled
distance is over 800 meters at 10:00:50, it will send out one report and re-start to
count the report interval and the traveled distance. The next report will be sent
out at 10:01:50 or when the traveled distance is over 800 meters.
Code
word
Parameter Value Description
P0 Report interval 1~4 Giga seconds
P2 Report Media Media type
Please refer to 2.9
Report media
P3
Traveled distance
for sending report
1~4 Giga
Unit: meter
0=disable
checking distance
Commands format:
GS C ,IMEI,M2*Checksum!
Command Codeword Parameter
M2 Set periodic mode
Example 1:
Set TR-206 periodic report and ask it to report based on traveled distance (P3) of
500 meters (Send command via SMS or TCP or UDP), turn on GPS by timer 1: Start
time:12:00 AM (X0=0), End time:12:00 AM (X1=86400), Report interval:30 seconds