GLOBALSAT TR-206 - Manual (Page 49)

48
6.4 Motion Mode
TR-206 has built in a motion sensor to detect the movement or vibration. Using
this feature, the device can work in moving state or static state. Each state has
independent parameters to control the behavior.
Basically, TR-206 will send report periodically according to the interval defined
for the working state. You may set a short interval for moving state and a long
interval for static state to save transmission fee.
n
Receive command and then enter motion static mode.
o
When TR-206 detects motion, it will enter motion moving mode and
send “static to moving” report.
p
Motion Moving Report.
q
When TR-206 is static, it will send “moving to static” report and then
return to the motion static mode.
r
Re-start timer for motion static interval.
s
Motion Static Report.
In moving state, GPS can be configured to be always on for GPS related function
to work properly. The device will terminate GPRS connection after sending
reports. But you may set GPRS to be always on-line so that server can send
message to device at any time. Please refer to section “4.3 GPRS connection”
for the usage of always on-line connection.
In moving state, the traveled distance can be considered to generate report as
well as report interval, whatever criterion is matched first. Then the report is sent
and the device re-starts to check distance and interval. You may need to keep
GPS on for this function to work by setting RH=1.
n
o p q
r
Time
R0 (Static interval)
R1 (Moving interval)
(Static Report)
(Moving Report)
(Static to Moving Report)
(Moving to Static Report)
s