Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (PDA) Compatible w_ Optional PowerPDA - Manual (Page 29)

9.
Locate the Banks Ram-Air filter
housing cover. Install the previously
removed air filter minder rubber
grommet into the Banks Ram-Air
filter housing cover. Once rubber
grommet is installed flush into the
Banks Ram-Air cover, then locate the
previously removed air filter minder
and install into the rubber grommet.
Make sure air filter minder is installed
flush to rubber grommet.
10.
Locate the Banks Ram-Air filter
and the Banks filter hose clamp.
Loosely fit the Banks Ram-Air filter
clamp to the Banks Ram-Air filter.
Note: See Figure 31 to reference the
correct alignment locater grove to
the Banks Ram-Air filter.
11.
After verifying the correct
alignment between the Banks
Ram-Air filter and the Banks Ram-
Air cover, snap fit the two pieces
together until an audible snap is
heard. This process will ensure that a
correct seal has been established.
12.
Tighten the Banks Ram-Air filter
hose clamp to the Banks Ram-Air
filter cover.
13.
Place the Banks Ram-Air filter
cover onto the Banks Ram-Air housing.
Locate the screws for the Banks Ram-
Air housing cover in your kit. Align and
loosely fit the Banks Ram-Air cover
onto the Banks Ram-Air housing.
Note: Use the Banks Ram-Air cover
and Banks Ram-Air housing to fine
tune alignment between Banks Ram-
Air intake tube and Banks Ram- Air
filter cover. The Banks Intake Tube can
be rotated to facilitate in alignment.
See Figure 32 and Figure 33.
CAuTIoN: Ensure Intake tube
is not touching any engine
components, specifically the
boost tube and intake manifold
hose clamps.
14.
Tighten the upper (top) hose
clamp intake tube.
15.
Remove the Banks Ram-Air
housing cover screws and remove
the Banks Ram-Air housing cover.
Note: Be careful not to disturb the
alignment.
Figure 31
Figure 32
Figure 33
96776 v.11.0
29