Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (PDA) Compatible w_ Optional PowerPDA User Manual
Page 42
If the Banks EconoMind Diesel Tuner
has been moved to a different
vehicle, or you are instructed to
do so by Banks Technical Staff,
it is possible to reset all of the
parameters that the EconoMind has
‘learned’.
CAuTIoN: The following
procedures can only be carried
out with the engine oFF!
1.
Turn the vehicle key to ON but Do
NoT start the engine.
2.
Fully depress the throttle pedal
and then release it completely.
Repeat 5 times. The GREEN LED
will flash when this is completed
successfully.
3.
Turn the key OFF. Wait 30
seconds, or until the GREEN LED goes
off and stays off. Turn the key back
to the ON position but Do NoT start
the engine.
4.
Fully depress the throttle pedal
and then release it completely.
Repeat 5 times
-END, SEcTION 11-
The Banks PowerPDA is designed
such that new software updates
can be easily installed. check the
BanksPower web site at <http://
www.bankspower.com/downloads>
for the latest version of the Banks
PowerPDA software. Once you have
determined that your Banks Power-
PDA should be updated, follow the
instructions on the page for the ap-
propriate software update.
The Banks EconoMind Diesel Tuner
is designed such that new firmware
updates can be easily installed. check
the BanksPower web site at <http://
www.bankspower.com/downloads>
for the latest version of the Banks
EconoMind Diesel Tuner firmware.
Once you have determined that your
Banks EconoMind Diesel Tuner should
be updated, follow the instructions on
the page for the appropriate firmware
update.
END, SEcTION 12-
If the Banks EconoMind Diesel Tuner
should ever need to be removed
from the vehicle, perform the
following:
1.
Disconnect the EconoMind’s
38-pin connector from the factory
harness.
2.
Re-connect the vehicle’s 38-pin
connector back into the factory
harness.
3.
Disconnect the EconoMind’s
24-pin connector from the factory
harness.
4.
Re-connect the vehicle’s 24-pin
connector back into the factory
harness.
5.
Disconnect the 2-ring terminals
from the EGT thermocouple.
6.
Disconnect the 3 small connectors
on the ‘In-cab cable’ and gently pull
the cable back through the firewall.
7.
Remove the Banks EconoMind
Diesel Tuner.
Note: Failure to follow the above
instructions when removing the
module will result in a “Check
Engine” light on the dash and a
Diagnostic Trouble Code being stored
in the factory computer, in addition
to the engine not running.
-END, SEcTION 13-
Section 13
REMoVAL oF THE ECoNoMIND DIESEL TuNER
Section 11
CLEARING LEARNED PARAMETERS
Section 12
uPDATING youR BANkS PoWERPDA SoFTWARE & BANkS ECoNoMIND DIESEL TuNER FIRMWARE
42
96776 v.11.0