Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-04 For use with Six-Gun Switch - Manual (Page 14)

14
96448 v.12.0
Figure 9
CAUTION: It is very important that
you select the proper wire. The
Banks Six-Gun Diesel Tuner will
not function properly if installed
incorrectly.
For 2003 automatic transmission
vehicles, follow Steps 14 through
17. For 2003 vehicles with a manual
transmission, skip to Step 17.
For 2004 vehicles with an automatic
transmission, follow Steps 18
through 20. For 2004 vehicles with a
manual transmission, skip to Step 21.
14.
FOR 2003 AUTOMATIc
TRANSMISSION VEHIcLES ONLY: Route
the GRAY Banks Tcc monitor wire
along the top of the firewall toward
the PcM on the passenger side. Undo
the clips (10 locations) and lay the
GRAY wire next to the factory wires.
See Figure 9. Use a cable tie to secure
the Tcc wire at the outlet.
15.
Locate the three (3) PcM
connectors on the passenger side. On
the middle connector (usually white),
find the orange wire with black stripe.
Remove electrical tape on the factory
harness if necessary and install a
T-tap. Plug the GRAY Tcc wire into
it. See Figure 10. Re-install the clips
along the top of the firewall.
Note: Disconnecting the PCM
connection might make the task easier.
16.
Locate the solid RED wire in
the wire loom entering the c130
connector. This is the same connector
removed in Step 1. Install a T-tap on
the RED wire and plug the BLUE Tcc
wire into it. See Figure 11.