Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-04 For use with Six-Gun Switch - Manual (Page 22)

22
96448 v.12.0
9.
After confirming the locating
washer is in the #6 location, install the
switch through the 3 ⁄
8
” hole on the
backside of the bezel. The alignment
pin should rest in the 1 ⁄
8
” hole and
with the switch fully rotated counter
clockwise; the shaft’s flat side should
be facing the steering column. Secure
switch with internal tooth washer and
nut. Snug the nut. Be careful not to
over torque the nut and damage the
plastic threads.
10.
Install the knob onto the shaft
facing the #1 Level on the Six-Gun
label. On the knob, snug the two (2)
set screws with the supplied 0.050”
hex key wrench.
11.
Reinstall the cluster bezel by
pressing on it to ensure all the clips
are engaged. Secure it with the
original two (2) screws.
12.
Reconnect the electrical
connector to the headlamp switch
bezel. Reinstall this bezel by gently
pushing on it until all clips are
engaged.
13.
Reconnect the four (4) electrical
connections to the center bezel.
Reinstall this bezel by pushing on it to
engage all the clips. Open the ashtray
and cup holder and reinstall the
original screw.
14.
Route the Six-Gun switch wires
down to the steering column.
15.
Remove the 2-pin jumper from
the Six-Gun Diesel Tuner wire harness.
Connect this Six-Gun harness to the
2-pin connector on the switch wire.
-END, SEcTION 2-