Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-04 For use with Six-Gun Switch - Manual (Page 19)

96448 v.12.0
19
21.
FOR ALL 2004 VEHIcLES
ONLY: Locate the two (2) electrical
connectors next to the main brake
cylinder. Find the pink wire with gray
stripe on the connector closest to the
brake cylinder. Install a T-tap on this
wire. Plug the Six-Gun Diesel Tuner red
wire into the T-tap. See Figure 14.
22.
Inside the cab, plug the main
8- and 10-pin connectors from the
wire loom into the front of the Six-
Gun Diesel Tuner box. On vehicles
with automatic transmissions, plug
the 4-pin Tcc wire harness connector
into the rear of the Six-Gun Diesel
Tuner box.
23.
In the engine compartment,
unbolt the nut from the ground (-)
terminal on the drivers side battery.
Locate the ring terminal on the Six-Gun
Diesel Tuner wire harness. Install this
ring terminal onto the battery ground
and re-install the nut. See Figure 15.
24.
FOR ALL 2003 VEHIcLES ONLY:
Reinstall the large black connector
(c130) that was removed in Step 1.
Note: Go over the entire installation as
a precautionary check to ensure that all
clamps are tight, wiring and hoses are
properly routed, and connections are
correct and tight. Make sure that the
wire harness is not lying in the way of
the brake and gas pedals.
-END, SEcTION 1-
Figure 15