Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-04 For use with Six-Gun Switch - Manual (Page 17)

96448 v.12.0
17
17.
FOR ALL 2003 VEHIcLES ONLY:
Locate the LIGHT GREEN wire with
BLAcK stripe in the wire loom entering
the c130 connector. This is the same
connector removed in Step 1. Install
a T-tap on this wire. Plug the red Six-
Gun Diesel Tuner wire into this T-tap.
Tie the excess RED wire to the wire
harness using the supplied cable ties.
Skip to Step 22.
18.
FOR 2004 AUTOMATIc
TRANSMISSION VEHIcLES ONLY: Plug
the TCC extension into the BLUE
Tcc wire. Using the wire harness on
the two (2) connectors next to the
main brake cylinder as a guide (see
Figure 12), route the BLUE and gray
Tcc wires toward the transmission
solenoid assembly that is sitting on the
transmission. It is located underneath
the drivers side of the vehicle. See
Figure 13A. Secure the wire using
cable ties along the way.
19.
Find the YELLOW wire with
ORANGE stripe on the solenoid
assembly. (There is a YELLOW wire
with a PINK stripe next to the yellow
wire with ORANGE stripe and it
may appear as a YELLOW wire with
ORANGE stripe. DO NOT T-tap this
YELLOW WIRE with PINK stripe!) Refer
to Figure 13B for the correct YELLOW
wire with ORANGE stripe pin number
and location. It is at pin #1. Apply
a generous amount of the supplied
dielectric grease into a T-tap and
install it on the YELLOW wire with
ORANGE stripe. Insert the BLUE Tcc
wire into this T-tap. See Figure 13C.
20.
Find the YELLOW wire with light
BLUE stripe. Apply a generous amount
of the supplied dielectric grease into a
T-tap and install it on this wire. Insert
the GRAY Tcc wire into this T-tap. See
Figure 13C.
Figure 13B