Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-04 For use with Six-Gun Switch - Manual (Page 9)

96448 v.12.0
9
SECTION 1
SIx-GUN DIESEL TUNER INSTaLLaTION
For 2003 vehicles, start from Step 1.
For 2004 vehicles, start from Step 2.
1.
FOR 2003 VEHIcLES ONLY: Locate
the large black connector (c130) on
the driver side between the battery
and the firewall. See Figure 1. Remove
the two (2) plastic screws on the
sides of the connector and move the
connector aside. Retain the two (2)
screws and the two (2) retainers for
re-installation.
2.
Locate the rubber grommet on the
drivers side firewall. Using a utility
knife, make a 1.5-inch-long slit in the
grommet next to the wire harness.
Be careful not to cut or damage
the harness. See Figure 2 for the
proper location of the required cut.
Insert a screwdriver from the engine
compartment into the cut hole and
thrust it through the grommet.
3.
Inside the vehicle, remove the
lower dash panel beneath the steering
column by removing the two (2)
screws at the bottom of the panel.
Retain the screws for re-installation.
Figure 1
Figure 2