Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Intake- Techni-Cooler Charge Air Cooler '07-08 - Manual (Page 6)

Figure 3 Upper Radiator Cross Brace
11.
Remove the hex head bolts that
attach the lower two a/c condenser
mounting brackets to the cac.
Remove the torx head bolts that fasten
the lower two mounting brackets to
the a/c condenser. Discard the stock
lower mounting brackets, but retain
the torx head bolts for re-use.
12.
Remove the hex head bolts that
attach the upper a/c condenser
mounting brackets to the cac.
13.
swing the a/c condenser upward
as shown in Figure 5, then out away
from the vehicle as shown in Figure 6.
Caution: Minimize the amount of
stress to the A/C condenser fluid
lines to prevent damage.
an assistant could be helpful to hold
the a/c condenser while the stock
cac is being removed and the Banks
techni-cooler is being installed.
14.
Remove the stock cac from the
vehicle.
15.
Remove the lower saddle mount
rubber bushings from the stock cac
and install them on the Banks techni-
cooler.
16.
Remove the upper rubber
isolators from the stock cac and
install them on the Banks techni-
cooler.
17.
install the Banks techni-cooler in
the vehicle.
18.
Remove all of the factory
brackets from the condenser, retain
the torx head bolts for reassembly.
the Banks condenser brackets are
stamped such that “R.U.” means Right
(passenger side) Upper and that the
“R.U.” is visible when the condenser is
installed. install the R.U. and relocate
L.U. brackets onto the condenser as
6
96787 v.4.0