Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Intake- Techni-Cooler Charge Air Cooler '07-08 - Manual (Page 9)

diameter hose all the way onto the
boost tube. install the boost tube in the
vehicle, make the attachment to the
turbocharger, then slide the 3.5 inch
diameter hose towards the techni-
cooler to complete the installation.
install the hose clamps on the
passenger side boost tube as shown
in Figure 7 to avoid clearance issues.
the clamps should be tightened to 5
ft-lbs (60 in-lbs). Note: Before installing
any boost tubes into position, remove
rag(s) covering the intake manifold and
turbocharger outlets.
29.
install the driver side boost tube.
the driver side tubes uses a 3.5 inch
diameter straight hose at the intake
manifold and a 3.5 inch diameter hump
hose at the cac. the orientation of
the hose clamps should be as shown
in Figure 8 to avoid clearance issues.
Note: To provide additional clearance
for installation of boost tube on driver
side, remove fuse box.
30.
make the connection between the
driver side boost tube and the intake
manifold. tighten all the driver side
hose clamps to 5 ft-lbs (60 in-lbs).
31.
Re-install the air box and inlet
tube assembly. Secure the air box
at the radiator cross brace with
the factory nut that was previously
removed. Re-connect the air inlet
temperature/ pressure sensor at the
air box cover. Re-connect the air inlet
duct to the turbocharger inlet. tighten
the hose clamp at the turbocharger
inlet to 8 ft-lbs (96 in-lbs).
32.
Re-connect the negative battery
cables.
Figure 7 Orientation of the Passenger Side Hose Clamps to avoid clearance issues.
96787 v.4.0
9