Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Intake- Techni-Cooler Charge Air Cooler '07-08 - Manual (Page 7)

shown in Figure 4. place the a/c
condenser back in front of the techni-
cooler and assemble the condenser to
the banks intercooler using the 5⁄16”
bolts and washers supplied with the
Banks Techni-Cooler system. Fasten
the top two a/c condenser mounts
to the techni-cooler. Keep the bolts
loose to aid in the alignment of the
lower two mounting brackets.
19.
install the R.L and relocte L.L
brackets onto the condenser such that
the intercooler boss and condenser
holes align.
20.
tighten the 5 ⁄
16
” bolts at each of
the a/c mounting brackets and torque
to 19 ft-lbs.
21.
Tighten the torx head bolts on
both of the lower and the upper a/c
mounting brackets.
22.
install the upper radiator cross
brace. Leave the bolts loose to aid in
the alignment of the cross brace with
the radiator and techni-cooler.
23.
Loosely install the upper cac
mounting bolts.
24.
Loosely install the upper radiator
mounting bolts.
25.
tighten the radiator cross brace
bolts and torque to 21 ft-lbs
26.
tighten the upper cac mounting
bolts and torque to 8 ft-lbs (96 in-lbs).
27.
tighten the upper radiator
mounting bolts and torque to 8 ft-lbs (96
in-lbs).
28.
install the passenger side boost
tube. the passenger side uses a 2.75
inch diameter straight hose at the
turbocharger connection, and a 3.5
inch diameter hump hose at the cac
connection. the passenger side tube is
most easily installed by placing the 2.75
inch straight hose as it will normally
reside on the boost tube when installed
on the vehicle. then slide the 3.5 inch
Figure 4 Relocation of the Upper Driver Side A/C Condenser Mounting Bracket
96787 v.4.0
7