Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Speed Control- Banks Exhaust Brake - Manual (Page 10)

Figure 12
Note: Be sure to cut the
correct color wire. There
may be a white wire with a
red tracer in close proximity
to the cruise control wire
and may easily be mistaken
for the right lead. Crimp the
male and female 1⁄4” spade
connectors to each end
of the cut wires. Connect
the two brown wires from
the harness to feed spade
connector.
19. Route the orange wire
along the underside of the
cowl lip towards the PCM.
20.
Locate the white wire
with orange stripe from
pin 27 at connector c2
(middle connector). Install
a supplied red T-tap onto
the wire. See Figure 7 .
21. Plug the connector
on the end of the orange
wire from the Banks Brake
harness into the red T-tap
installed in Step 20 .
22. Plug the connectors
on the green and black
wires from the Banks Brake
harness into the connectors
on the black solenoid valve
leads.
23. Route the gray wire
from the Banks Brake
harness towards the front
of the engine.
24. Locate the tan
wire with black stripe
at the Engine Coolant
Temperature (EcT) sensor.
Install a supplied red T-tap
onto the wire. See Figure
8 .
25. Plug the connector
on the end of the gray
wire from the Banks Brake
harness into the red T-tap
installed in Step 24 .
26. Remove the
accelerator pedal position
sensor assembly (APPS) by
loosening the three bolts as
shown in Figure 9 .
27. Locate the light blue
wire with black stripe
running into the APPS
connector under the APPS
assembly. Install a supplied
red T-tap onto the wire
approximately two inches
from the APPS assembly.
The wire may be covered
by convolute from the
factory. If so, peel the
factory convolute away
from the wire to allow for
installation of the red T-tap.
9 6 9 8 3 v . 1 2 . 0
|10