Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Speed Control- Banks Exhaust Brake - Manual (Page 11)

28.
Plug the connector
on the end of the blue
wire from the Banks Brake
harness into the red T-tap
installed in Step 27 .
29. Reinstall the APPS
assembly. Tighten the three
bolts to 105 in-lbs. (not
ft-lbs)
30. Find a suitable
mounting location for
the CBC module. Banks
recommends mounting the
CBC module in the location
shown in Figure 10 . Ensure
that the mounting surface
is clean and free of any
oil, grease, or dirt. Clean
and dry as required using a
cloth and rubbing alcohol or
similar solution.
31.
Peel the protective
backing from the foam tape
on the CBC module and
mount the CBC module as
shown in Figure 10 . The
CBC module should be
oriented with the connector
facing down. Apply light
pressure to the CBC module
by hand for 60 seconds
to seat the foam tape and
create a strong bond.
32. Using a factory screw,
attach the ring terminal on
the end of the black wire
from the 14-pin connector
on the Banks Brake harness
to the metal dash supports
(suitable chassis ground).
If a suitable factory screw
cannot be located, use the
supplied self-tapping screw.
33.
Plug the 14-pin
connector on the Banks
Brake harness into the CBC
module.
34.
Install the supplied
2-amp fuse into the fuse
holder on the Banks Brake
harness.
35. on 1998-2002
vehicles equipped with
manual transmissions
anD 1998 vehicles
equipped with automatic
transmission: Install a blue
T-tap on the 14 AWG black
wire with an orange tracer
located in the harness
running from the steering
column. Attach the black
fused power lead as shown
in Figure 10 .
Figure 13
11 |
9 6 9 8 3 v . 1 2 . 0