Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Programmer- AutoMind Programmer User Manual
Page 12
12
97270 v.4.0
Section 5
RESTORING FACTORY TUNE
The stock calibration can be
reinstalled at any time by following
the instructions below. This feature
will remove the Banks AutoMind
calibration and will return the vehicle
to its stock condition. The Banks
AutoMind calibration will be saved in
the Banks AutoMind programmer.
1.
Plug the OBD II connector from your
Banks AutoMind programmer into the
OBDII connection port of your vehicle.
2.
Choose ‘TUNE VEHICLE’ in the
main menu screen and press the ‘OK’
button.
3.
Select ‘QUICK TUNE’ and press ‘OK’
to continue.
4.
Scroll up or down to highlight the
‘Stock’ calibration and press the ‘OK’
button. See Figure 6.
5.
Press the ‘OK’ button to continue
restoring stock calibration or ‘Left’
button to abort and go to the previous
menu.
6.
Follow the on screen instructions
and turn the ignition key ‘ON’ when
prompted by the programmer, but do
not start the engine.
WARNING: Unplugging the
Banks AutoMind Programmer
while uploading or
downloading a calibration can
damage the vehicles ECM.
7.
The data transfer may take a few
minutes to complete. Once the upload
is complete you will be instructed to
“Turn Ignition Switch OFF and Remove
Key, Press OK to continue.” See
Figure 5.
8.
The original factory stock
calibration restoration is complete.
You may unplug the Banks AutoMind
Programmer and drive your vehicle.
-END, SECTION 5-
Figure 6