Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Programmer- AutoMind Programmer User Manual
Page 16
Section 9
TROUBLESHOOTING
Table 1
Event
Course of Action
1
Banks AutoMind
Programmer will not power
up when I plug it into the
OBDII port
Make sure that the cigarette lighter or OBD
II fuse in your vehicle is functional. You may
also want to try plugging the Banks AutoMind
Programmer into any other vehicle with an
OBDII port to see if it powers up. If it does
not, please return to point of purchase for a
warranty exchange.
2
Banks AutoMind
Programmer lights up, but
nothing happens.
Please contact Gale Banks Engineering
Technical service department for further
assistance.
3
Banks AutoMind
Programmer is flashing
“Script error: Interpreter
stopped.” Verify that you
have done the following:
-Check to see that all fuses in the fuse panel
are good.
-Make sure you have disabled any
aftermarket electronics in the vehicle such as
alarm systems, stereos, CD players etc.
-Removed anything that is plugged into the
cigarette lighter.
4
Banks AutoMind
Programmer says “Vehicle
Not Supported”
Please contact Gale Banks Engineering
customer service department for further
assistance.
5
Error 22- Time Out
Press ‘OK’ and restart.
6
Error 25- Comm Failure
Key was not turned ON in enough time. Leave
key in the ON position and press the ‘OK’
button to restart.
7
Error 48- DLCS- Time Out
Data link communications system (DLCS)
timed out. press ‘OK’ and restart.
8
Program Failed, Press OK
Press ‘OK’ and try again.
Gale Banks Engineering
546 Duggan Avenue • Azusa, CA 91702
(626) 969-9600 • Fax (626) 334-1743
Product Information & Sales: (888) 635-4565
Customer Support: (888) 839-5600
Installation Support: (888) 839-2700
bankspower.com